Ooops! I did it again
Can any one tell me, why it always Blasts when I insert two different(not connected with each other) copper wire into the MAIN switch(220/250 VA ) ??? 'No pain, no gain' tar poreo boltesi 'Plz dont try this at home or at school!'
r@k€€/|/
Re: Ooops! I did it again
Because you make the circuit complete by doing this, and then electricity is turned into heat and light within a few seconds, and BANG!
"Inspiration is needed in geometry, just as much as in poetry." -- Aleksandr Pushkin
Please install LaTeX fonts in your PC for better looking equations,
learn how to write equations, and don't forget to read Forum Guide and Rules.
Please install LaTeX fonts in your PC for better looking equations,
learn how to write equations, and don't forget to read Forum Guide and Rules.
Re: Ooops! I did it again
hey,hey, how is the circuit complete. I've not connected the two wire! I've just put them in the plug separately.
r@k€€/|/
- Abhijeet Dutta
- Posts:50
- Joined:Mon Dec 27, 2010 11:39 pm
- Location:Bangladesh
- Contact:
Re: Ooops! I did it again
you didn't say what blasts , not surely only the wire burns
and you put them in the plug where one is positive and another negative , it can still complete the circuit
and you put them in the plug where one is positive and another negative , it can still complete the circuit
Shout aloud scream aloud let me hear you go